United States Stove 6041TP, 6041I, 6041HF Control Board Functions, START-UP Sequence of Events

CONTROL BOARD FUNCTIONS

START-UP SEQUENCE OF EVENTS

Once the control panel is turned on, a timer begins that will start, stop and continue operation of the Multi-fuel

Heater as a preset temperature is achieved.

COMPONENT	OPERATION START	OPERATION END
Draft Fan	Starts Immediately	Will continue until shutdown. Shutdown will occur
		when the operating temperature is below approx. 90
		degrees.
Agitator	Begins to turn once the heater reaches op-	Will continue intermediately, as determined by the
	erating temperature	“HEAT SETTING”, until shutdown.
Auger	In Pellet mode: Auger turns immediately.	The auger will continue at the feed rate specified by
	In Corn mode: Three minutes after starting,	the “HEAT SETTING”.
		NOTE: Safety switches, HI limit and vacuum sensor,
	the auger will begin to turn	must be activated to continue proper operation.
Room Fan	Begins to run when heater reaches operat-	Will continue to operate until the heater cools down to
	ing temperature	below approx. 90 degrees. This may take several hours.
Automatic Shutdown	If after 15 minutes, the heater has not	Should the timer expire before the preset operating
	reached the preset operating temperature,	temperature is achieved, simply reset the heater by
	the unit will begin to automatically shut	pressing the “ON” button.
	down.
Normal Operation	If after 15 minutes the preset operating tem-	Operation will continue until either the heater’s control
	perature of approx. 110 degrees is achieved,	is to the “OFF” position, or the operating temperature
	normal operation will continue.	falls below approx. 90 degrees. At such time the heater
		will default to the “Automatic Shut Down”.
Igniter	Starts immediately	Will continue operation for a preset time, then shut-off

SHUTDOWN SEQUENCE OF EVENTS

Once the Heater has reached the normal operating temperature and switched to the “OFF” position, the unit will initiate a slow down, reducing the fuel rate until the heater’s “LOW LIMIT SAFETY” sensor tells the control board it is safe to shutdown.

COMPONENT	SHUTDOWN	OPERATION END
Draft Fan	Unchanged operation until preset “OFF”	Continues until the operating temperature falls below
	temperature is achieved.	approx. 90 degrees. May take several hours.
Agitator	Rotates continuously until preset “OFF” tem-	Continues until the operating temperature falls below
	perature is achieved.	approx. 90 degrees.
Auger	Slows down to a reduced fuel setting until	The auger will continue at the reduced feed rates
	preset “OFF” temperature is achieved.	until the operating temperature falls below approx.
		90 degrees.
		NOTE: Safety switches, HI limit and vacuum sensor,
		must be activated to continue proper operation.
Room Fan	Unchanged operation until preset “OFF”	Will continue to operate until the heater cools down to
	temperature is achieved.	below approx. 90 degrees. This may take several hours.
Automatic Shutdown	If the heater’s “HI LIMIT” sensor snaps open,	It is rare that the HI LIMIT temperature is reached.
	this will cause an automatic shutdown. An	However, should this error occur, let the heater cool
	error code will be displayed (Err1). NOTE:	down for an hour then restart.
	“HI LIMIT” errors are usually the result of
	operating at the highest heat setting for long
	periods of time, room fan failure or loose
	wire connection.

CAUTION: When performing any internal electrical maintenance

•Moving parts inside of the cabinet may cause injury. Do not operate unit with panels removed or open.

•HOT parts. Do not operate the unit with panel open.

•Risk of electric shock. Disconnect power before servicing unit.

•In the event of component failure, replace with the original factory equipment.

22 USSC