CAUTION
Never allow sunlight to shine directly into the security floodlight sensor prior to, during or after installation. Direct sunlight could damage the sensor.
2.Remove the preassembled security floodlight from the box.
Locate shield slots and push down over four retainer pins.
Turn to lock in place.
3.Observe three controls on the sensor. Rotate SENS/RANGE (sensitivity) control fully clockwise. Rotate DAYLIGHT/TEST- ON control fully counterclockwise. Rotate TIME (Time Delay) control fully counterclockwise.
ADJUST
SENS DAYLIGHT TIME
RANGE
4.Place all wires of the security floodlight through the gasket. Locate the gasket against the back side of the cover. The security floodlight is ready for outdoor installation.
WHITE | GREEN | |
(IF SUPPLIED) | ||
| ||
BLACK |
|
GASKET
Removing an Old Floodlight Assembly (if there is one)
Remove an old floodlight assembly as follows:
WARNING
The old floodlight should only be removed and the new security floodlight installed by persons experienced and licensed in household electrical wiring.
