5.
Models
MODELS
ASSEMBLY INSTRUCTIONS
Figure 6 | Attach the electrode wires to the piezo Ignitor as |
| |
| shown in Figures 6 & 7. |
Figure 7
OPERATING INSTRUCTIONS
MODELS SPC-15R/15R SPC-30R/30R
PREPARING FOR OPERATION
1.Check the heater for possible shipping damage. If any is found, immediately notifiy the factory.
2.Follow all of the Safety and Operating Precautions.
3.Refer to the exploded view for general assembly layout.
4.Check the "O" ring on the POL before each use. Replace the "O" ring if there is any sign of wear or damage.
5.Make sure heater regulator knob is on the "OFF" position.
6.(A) Attach the heater (30R only) to the guard on the propane cylinder with the body of the stand on the inside of the guard and the bolts through two holes in the guard (see Figure 1). Tighten the latching plate into place using the wing nuts
provided (see Figure 2).
6.(B) Connect the POL fitting at regulator (15R/30R) to the propane cylinder by rotating the POL nut
7.Securely tighen all gas connections.
8.Open the cylinder's gas valve and check all gas connections with a soap and water solution. DO NOT USE A FLAME.
Figure 1
Figure 2
Page