Models
MODELS
ASSEMBLY INSTRUCTIONS
1.Inspect the heater components for possible shipping damage. If any is found, immediately notify the dealer.
2.Follow the following instructions to assemble the
| Check to make sure that all of the following packaged | |
| components (see Figure 1) are incuded. |
|
| Burner Assembly w/ regulator | 1 |
| Burner Assembly w/o regulator | 1 |
1. | Heater Support | 1 |
| Tank Plate | 1 |
| Wing Nuts | 2 |
| Burner Clamp | 2 |
| Burner Mtg. Screw | 2 |
| Piezo Ignitor | 1 |
| Piezo Mtg. Nut | 1 |
| Figure 1 |
|
| Insert the piezo ingitor into the bracket on the burner |
| support as shown in Figure 2. Then tighten the piezo- |
| mounting nut. Care should be taken not to over |
2. | tighten the nut. |
|
Figure 2
Page
