Tv/Vcr | Universal Electronics 4-DEVICE Universal Remote Control

PROGRAMMING TV/VCR COMBO CONTROL

3. (continued)

NOTE: If the VCR key did not blink twice after enter- ing the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

If you’ve located a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see Programming Device Control on page 8).

4. Aim the remote control at your TV/VCR Combo and press POWER once. The device should turn off. If it does not respond, repeat steps 2-3 (starting on the previous page), trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 20).

5.For future reference, write down each working device code in the boxes below:

TV/VCR

TV (if used)

10

Image 10

Universal Electronics 4-DEVICE Universal Remote Control manual Tv/Vcr

Contents

Atlas Cable 4-DEVICE Table of Contents Introduction Code library for popular video and audio devices Features and Functions Use Setup for all programming sequences Key ChartsUse Guide to display the program guide Press Mute once to turn the sound off or on Use CH+ or CH- to select the next higher or lower channel Installing Batteries Installing Batteries Programming Device Control AUD TV/VCR Setup Codes for Audio Receivers Setup Codes for Audio AmplifiersMANUFACTURER’S Codes ABC Setup Codes for Cable ConvertersSetup Codes for DVD Players GPX Setup Codes for VCRs and PVRs CCE KLH HI-QKEC LXI STS NECTMK AOC Setup Codes for TVsCXC NAD JCBKTV NTC SSS Setup Codes for TV/VCR Combos Press Setup once to lock in the code Searching for Your Code Checking the Codes Enter 9 8 2. The CBL key will blink four times Programming ID LockTurn on the cable converter Enter 9 8 2. The CBL key will blink twice Programming Channel Control Lock Enter 9 7 Press CH- once. The CBL key will blink four times To Operate The Master Power Key To Program The Master Power KeyTo Clear The Master Power Key Perform steps 1 and 2 in the above section Press Power once RE-ASSIGNING Device Keys TV VCR Using Macros Example Programming a Favorite Channel To Clear a Macro Changing Volume Lock To Unlock All Volume Control Global Volume Unlock To Lock Volume Control To One Mode Global Volume Lock Problem TroubleshootingSolution Additional Information M4030 04/02