21
CHECKING THE CODES Ifyou have set up the Atlas Universal Remote Control
using the Searching For Your Codeprocedure (on the
previous page),you may need to find out which four-digit
code is operating your equipment.For example,to find
out which code is operating your TV:
1. On the remote control,press TVonce.
Then press and hold SETUPuntil the
TVkey blinks twice, then release SETUP.
2. Enter 9- 9- 0.The TVkey will blink twice.
3. To view the code for the first digit,press 1once.
Wait 3 seconds and count the number oftimes
the TVkey blinks (e.g., 3 blinks = 3) and write
down the number in the leftmost TV Code box
(see below).
NOTE:If a code digit is “0”,the selected mode key will
not blink.
4. Repeat step 3 three more times for remaining
digits.Use 2for the second digit,3for the third
digit,and 4for the fourth digit.Finish writing
down the code in the TV Code boxes below.
5. To check for other device codes,repeat steps 1
through 4,but substitute the appropriate key
(i.e.,AUD,VCR,or CABLE) for the (Audio,VCR,
or Cable) device you are checking.Write down
the codes in the appropriate boxes below.
AUD Code
Audio Device ____________________
VCR Code
TV Code
CABLE Code
Atlas Manual 4/8/02 9:37 AM Page 21