Universal Electronics DVR M1055F manual Programming the F1 KEY For Specific Channels

PROGRAMMING THE F1 KEY

FOR SPECIFIC CHANNELS

The Cogeco Atlas DVR 5-Device Universal Remote Control includes a programmable F1 key (located directly below the LAST key).

The F1 key can be programmed to remember five of your favorite cable channel settings. If you want to change the cable channels previously-programmed on the F1 key, you’ll need to clear the key first (see the next page).

To Program The F1 Key:

1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice, then release SETUP.

2. Enter 9 - 9 - 5. The CBL key will blink twice. Then select the F1 key and press

it once.

3.Press CBL once followed by the channel number to be programmed (e.g., 0 - 3 - 9).

4. Press and hold SETUP until the CBL key blinks twice, then release SETUP.

5.To add another channel, repeat steps 1 through 4, substituting the new channel to be added in step 3.

NOTE: Programming more than five channels on the same F1 key will overwrite previous settings.

16