1.Turn on the cable converter.
2.On the remote control, press CBL once; it blinks once. Then press and hold SETUP until the CBL key blinks twice.
3.Enter 9 8 2. The CBL key blinks four times,
indicating ID Lock is unlocked.
4.Perform the instructions under “Programming Device Control” on page 12 to program device control for the desired cable converter.
When you are done, perform steps 5 and 6 on this page to again lock the ID Lock.
5.On the remote control, press CBL once; it blinks once. Then press and hold SETUP until the CBL key blinks twice.
6.Enter 9 8 2. The CBL key blinks twice,
indicating ID Lock is again locked.
LOCKING THE VOLUME TO YOUR CABLE BOX
Normally, the Polaris Remote Control is locked to control the volume of your television only. However, if you have an older television that does not have a remote control for the volume, you have to control your television’s volume through your cable box. To lock the volume control to your cable box, perform the steps below:
www.urcsupport.com
15
