IMPVE4P manual 1.0 4/11/03 4:34 PM Page 16
PROGRAMMING FAVORITE CHANNEL SCAN
In the DVD/VCR, CBL/SAT, or TV mode, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when FAV is pressed (see Using Channel Scan on the previous page).
NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV is pressed while in another mode, the remote control will start scanning all channels instead (if applicable to the selected device).
1. 
On the remote control, press DVD/VCR, CBL/SAT, or TV once.
2. 
Press and hold SET until the LED (red light)
blinks twice, then release SET.
3. 
Enter 9 - 9 - 6. The LED will blink twice.
4. 
Use the keypad to enter a favorite channel number (e.g., 031). Then press SET once.
NOTE: If the original remote control required pressing an Enter key to change the channel, also press the ENTER key after the channel number (e.g., 0 - 3 - 1 - ENTER).
5.If desired, repeat step 4 for each channel to be stored, up to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote control will automatically exit programming.
6. 
To exit programming with less than
10 favorite channels stored, press and hold SET until the LED blinks twice. Otherwise, the remote control will automatically exit the program after ten channels have been stored.
16
