IMPVE4P manual 1.0 4/11/03 4:34 PM Page 9
PROGRAMMING DEVICE CONTROL
The One For All DVD Expert Universal Remote Control is preprogrammed at the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable box, and a Pioneer audio receiver/amplifier. To control devices other than the default brands, perform the following steps; otherwise skip this section:
1.Turn on a desired device (e.g.,VCR or DVD player) and, if applicable, insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before starting step 2.
2.On the remote control,press a device key once (i.e., DVD/VCR, AUX, CBL/SAT,or TV).
NOTE: To program control of a DVD device,
VCR, PVR (or DVR), VCR/DVD Combo, or
DVD/VCR once.
NOTE: To program control of an Audio
Amplifier or Receiver, press AUX once.
NOTE: To program control of a Cable Box, Satellite Receiver, or a Satellite Receiver/PVR (or DVR) Combo, press CBL/SAT once.
NOTE: To program control of a TV/VCR Combo, press DVD/VCR once. After programming, you will be able to control channel selection, volume, and VCR functions.
NOTE: To program control of a TV/DVD Player Combo, press DVD/VCR once. After program- ming, you will be able to control channel selection, volume, and DVD functions.
3. 
Press and hold SET until the LED (red light)
blinks twice, then release SET.
4.Use the Manufacturer’s Codes (starting on page 18) to locate the type of device and brand name and then enter the first four- digit code for your device. If performed correctly, the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code again.
continued on next page...
9
