ASSEMBLYINSTRUCTIONSFOR USINGYOURUNITWITHTHE OPTIONALVACUUMATTACHMENT
NOTE:Assemblyinstructionsfor using
your unitas a blowerare explainedin the previousses_on, ff you have already assembledyour unitfor use as a blower, removetheblotler tube and nozzis.
WARNING: Stop the un'and discon- nect from the power source before opening the inlet cover or attemptingto insert or remove the inlet restrictoror vacuum tubes. The motor must be
stopped and the impeller blades no
longer turning to avoid serious injury from the rotating blades.
REMOVE THE INLET RESTRICTOR
An inletrestdctoris used when using ycur unitas a blower.This restrictoris not useddudngvacuum .se, and must be removedduringassemblyfor vscu-
um use.
NOTE: Be sure to keep the inlet re- strictor for using your unit as a blower.
•Open the inlet cover by insertingthe tip of a screwdriverintothe inlet cover latcharea, and twistingthe screwdriver while pullingthe inletcover open.
Bottomview
unit
•Locate the arrows on the upper vac- uum tube and on the vacuum inlet
area of _he unit.
UpperVacuumTube
•While holdingthe inlet cover open, align the arrows and insertthe vacu- um tube intothe opening. Twist the tube dock'wiseuntilit is seated. A second arrow on the vacuum tube
will align with the arrow on the unit once the tube twisted completely in place.
Align arrows on tube & unit
•Attach the lower vacuum tube to the
upper vacuum tube by aligning the arrows on the two tubes. Press the
tubes together until the lower tube is fully seated in the upper tube. (About 3 inches)
•Rotate the inlet restrictorcounter- clockwise, and liftout of the unit.
Do not close the inlet door. You will next attach the vacuum tubes.
ATTACHING THE VACUUM TUBES
There are 2 vacuum tubes, an upper and lower tube. The upper tube is cut
straighton both ends, and attaches to the blower unit. The second tube is cut
an at angle on the lower end. This
ground during vacuum use.
Upper Lower
ATTACH THE COLLECTION BAG
Slide the opening of the collection bag over the blower outlet. Pull the strap with Velcro tightlythrough the budde and secure with Velcro tabs.
NOTE: Make sure the strap with Velcro is locatedon the blower outlet
as shown. Also, make sure the zipper on the bag is completely clnsed.
Strop with Velcro
C,dlectlon |
|
Bag | Mower Outer |
6