ADJUSTING THE SHOULDER STRAP
ON THE COLLECTION BAG
•Carefully loop the shoulder strap through the buckle as shown in the illustration below.
Last In
First In
•Positionthe unit on your
uptight position, and supportthe low- er vacuum tube on the ground.
•Place the shoulder strap over your head and onto your left shoulder.
•Adjust the strap to allow a free flow of air from the blower. If the collection
bag is kinked, the unit will not oper- ate properly.
NOTE: The strap is designed to position the collectionbeg on your shoulderwith- out kinks. The strap is not intendedto supportthe weight of the unit..
Shoulder strap on leftshoulder
No kinks in
Allows free air flow
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE.
•Stop unit and unplug the extension cord.
•Remove the vacuum tubes and collection bag.
•InslstF_irJnlet restdctorthat was re- moved when assembling for vacuum
NOTE: If you are unable to locate the inlet restrictor, the unit will still operate.
This restdctor improves the blower function.
•Close the inlet cover and make sure it is latched closed.
•
TUBE AND NOZZLE for instructions on how to attach these items.
EXTENSION CORD
Use only a 120 A.C. voltagesupply as shown on nameplate of the unit.
The extension cord used to reach the power soume must be:
•Specifically marked as suitable for outdoor use. The cord must be marked with the suffix
•Heavy enough to carry current from
the power source the full length of extension cord to the unit. Otherwise,
lossof power and overheating can occur causing damage to unit. Refer
to chart for minimumwire gauge rec- ommendations. The cord must be
marked with the proper wire gauge. (Appropriateextension cords are available.) Do not use multiple cords.
•In good condition.Cord insulation must be intact with no cracks or
deterioration. Plug connectors must be undamaged.
MINIMUMWIRE GAUGE
RECOMMENDATIONS
VC)LTSi25 FT. | 50 FT. | 100FT. |
120 1616 14-
A.W.G." A.W.G." A.W.G."
•AmericanWireG=uge
Secure extensioncord to unitusing the accessory cord lock (if equipped) or as follows:
•"Rethe power plug on the unit to the extension cord as shown.
•Insert plug into cord socket.
Power Plug on | Extension |
Unit,_Cord
use.