Univex WFS709TP manual Status Description

Models: WFS709TP

1 36
Download 36 pages 3.48 Kb
Page 16
Image 16

WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide

Port LNK/ACT LEDs. Each FE port has its own LNK/ACT LED on the upper-left side of the port. During operation, these LEDs provide the following Ethernet link status information:

Status

Description

 

 

Off

No Ethernet link on the port.

 

 

Green

An Ethernet link has been established on the port, but no data is currently being

 

transmitted or received.

 

 

Flashing Green

The port is transmitting or receiving data. The flashing rate is proportional to the

 

network activity.

 

 

Amber

The Ethernet link on the port is encountering errors.

Port PoE LEDs. Each FE port has its own PoE LED on the upper-right side of the port. This LED provides the following PoE status information:

Status

Description

 

 

Off

The port is disabled, or the attached device has not requested power. PoE is not being

 

provided by the port.

 

 

Green

PoE is being provided to the attached device.

 

 

Amber

The attached device has requested power, but POE is not being provided by the port.

ACCESS POINT STATUS LEDs. Each FE port has an identically numbered Access Point Status LED that represents the status of APs connected to that port on the WFS709TP ProSafe Smart Wireless Switch. During operation, the LEDs provide the following AP status information:

Status

Description

 

 

Red (solid)

An AP on this port has failed (highest precedence).

 

 

Red (flashing)

An air monitor on this port has detected an unsecured AP. The AP is attached to your

 

network but is not listed in the security policies. If security policies are enabled, clients

 

are not granted access to your network through the unsecured AP.

 

 

Green (flashing)

An air monitor on this port has detected interference. The interfering device (AP or

 

other radio source) has been detected by your valid APs, but has no wired presence

 

on your network.

 

 

Amber (solid)

Load balancing is enabled on this port, or an AP has reached the maximum number of

 

clients it is configured to support.

 

 

Green (solid)

All detected APs on this port are operating as expected.

 

 

Off

No AP is detected on the port (lowest precedence).

1-4

Introduction

v1.0, May 2007

Page 16
Image 16
Univex WFS709TP manual Status Description