RULESFOR SAFEOPERATION(Continued)
mAn extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If extension cord must be used,
make sure:
a.That pins on plug of extension cord are the same number, size and shape as those of plug on charger.
b.That extension cord is properly wired and in good electrical condition; and
c.That wire size is large enough for AC
ampere rating of charger as specified below:
Cord Length (Feet) 25' 50' 100' 150'
Cord Size (AWG) 16 16 16 14
Note" AWG = American Wire Gage
nDO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG. If damaged,
ALook for this symbol to point out important safety is involved.
IMPORTANT INFORMATION FOR
When using your drill continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.
Note." This situation only occurs when continuous use of your drill causes the batteries to become hot. It
A WARNING:
have replaced immediately by a qualified serviceman.
MDo not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
MDo not disassemble charger; take it to a qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of electric shock or fire.
MTo reduce risk of electric shock, unplug charger from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce this risk.
lDo not use charger outdoors.
lDisconnect charger from power supply when not in use.
MSAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who
may use this tool. If you loan someone this tool, loan them these instructions also.
safety precautions. It means attention!H Your
RECHARGING HOT
does not occur under normal circumstances. Refer to
"CHARGING BATTERY PACK" for normal recharg- ing of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Sears repair center for electrical cheek.
The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wid_ Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields, available at Sears Retail Stores.
5
