20
INSTALLING
Continued
INSTALLING LOGS
WARNING
WARNING ICON | G 001 |
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
For Vintage Oak Log Model
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 16).
2.Locate the notches on the back of the front log (#2). Slide these notches over the tabs of the grate base (see Figure 17).
3.Locate the notches in the bottom of the crossover log (#3). Place the crossover log on top of the back log and front log. Make sure the notches of the crossover log line up with rectangular knobs on top of the back and front logs (see Figure 18).
4.Add lava rock around base of heater.
| Back Log |
|
| (#1) | Front Log |
Peg |
| (#2) |
Hole | Notch |
|
|
| |
| Peg |
|
Tabs of
Grate Base
Figure 16 - Installing Back Log | Figure 17 - Installing Front Log |
| |
Crossover |
|
Log (#3) | Notch |
| |
Notch | Rectangular Knob |
|
Rectangular Knob
Figure 18 - Installing Crossover Log
103515
