OPERATING HEATER
Continued
INSPECTING BURNERS
24
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater |
|
| |
1. | Press in and turn control knob clockwise | Clockwise | to the HIGH position. |
2. | Turn the control knob clockwise Clockwise | to the PILOT position. | |
3. | Press in control knob and turn clockwise | Clockwise | to the OFF Position. |
Shutting Off Burners Only (pilot stays lit)
1. | Turn the control knob clockwise Clockwise | to the HIGH position. |
2. | Press in and turn control knob clockwise | Clockwise to the PILOT position. |
MANUAL LIGHTING PROCEDURE
1.Follow steps 1 through 5 under Lighting Instructions, pages 22 and 23.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 8, page 23.
Check pilot flame pattern and burner flame patterns often.
PILOT FLAME PATTERN
Figure 23 shows a correct pilot flame pattern. Figure 24 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
Thermocouple | Pilot Burner | Thermocouple | Pilot Burner |
Figure 23 - Correct Pilot | Figure 24 - Incorrect Pilot |
Flame Pattern | Flame Pattern |
If pilot flame pattern is incorrect, as shown in Figure 24
•turn heater off (see To Turn Off Gas to Appliance, above)
•see Troubleshooting, pages 25 through 28
103515
