Vanguard Heating VMH3000TN Continued, Natural Gas Residential Heaters, Assembly

Models: VMH3000TN

1 24
Download 24 pages 28.82 Kb
Page 4
Image 4
Continued

®

NATURAL GAS RESIDENTIAL HEATERS

ASSEMBLY

Continued

Log

Front Panel

Screen

Truss-

Head

Screw

Nut

Brass Front Trim

Screw

Figure 4 - Assembling Heater

Attaching Brass Front Trim to Front Panel WARNING: Always have burner shield and screen in place before operating heater. This pre- vents excessive temperatures on heater surfaces.

Failure to position the parts in accordance with these diagrams or failure to use only parts spe- cifically approved with this heater may result in property damage or personal injury.

Attaching Brass Front Trim to Front Panel

1.Locate brass front trim in brass trim package.

2.Slide the head of two truss-head screws from hardware packet into each end of brass front trim (see Figure 5).

3.Line up screws with holes in front panel (see Figure 4). Insert screws in holes. Attach nuts from inside of front panel. Tighten with wrench.

Heater Cabinet

Deflector

Log

Assembling and Attaching Brass Trim Retaining

Brackets

Burner Shield

Screw

Brass Front

Front Panel

Trim

 

Nut

Truss-Head

Screw

Figure 5 - Attaching Brass Front Trim to Front Panel

Assembling and Attaching Brass Trim

1.Remove packaging from remaining three pieces of brass trim.

2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 5.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 6).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 6).

6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

8.Place the assembled trim on front of heater cabinet. Attach on top and sides with four brass screws included in hard- ware package (see Figure 7).

9.Reattach front panel to heater if you are going to mount the heater to the base. Do not reattach front panel at this time if you are going to mount heater to wall.

Top Brass

Adjusting Trim

Side Brass Plate

Trim

Set

Screws

Shim

Slot

Slot

Mitered Edge

Figure 6 - Assembling Brass Trim

Screws

Assembled

Brass Trim

Figure 7 - Attaching Brass Trim to Heater

4

104431

Page 4
Image 4
Vanguard Heating VMH3000TN Continued, Natural Gas Residential Heaters, Assembly, Attaching Brass Front Trim to Front Panel