14
OPERATING HEATER
To Select Heating Level
To Turn Off Gas To Appliance
Manual Lighting Procedure
OPERATING HEATER (THERMOSTAT MODELS)
For Your Safety Read Before Lighting
OPERATING HEATER
NON-THERMOSTAT MODELS (Continued)
TO SELECT HEATING LEVEL
WARNING: When running heater, set control knob at LOW, MEDIUM, or HIGH locked positions. Never set control knob between locked positions. Poor combustion and higher levels of carbon monox- ide may result.
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
Slightly press in control knob and turn counterclockwise
to the LOW, MEDIUM, or HIGH positions (see Figure 21).
IMPORTANT: Release downward pressure while turning con- trol knob. Control knob will lock at the desired position.
Control | VN18 | VN30 | |||
| Knob | VP16 | VP26 | ||
|
| H |
|
|
|
|
| I |
|
|
|
MED |
|
|
|
|
|
LOW |
|
|
|
|
|
|
| PILOT | F |
|
|
|
|
| F |
|
|
|
|
| O |
|
|
|
|
|
|
| LOW |
H |
|
|
|
| |
I |
|
|
| ||
MED |
|
|
|
|
|
LOW |
| OFF |
|
| |
| PILOT |
|
| ||
|
|
|
|
| |
|
|
|
|
| MED |
|
|
| O |
|
|
|
|
| FF |
|
|
HI |
|
|
|
|
|
M | E | D | PILOT |
|
|
|
| LOW |
|
| |
|
|
|
|
| |
|
|
|
|
| HIGH |
PILOT | LOW |
|
| ||
|
|
| MED |
|
|
OFF |
|
|
|
|
|
|
|
| HI |
|
|
OFF
Figure 21 - Burner Patterns for
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise 
to the OFF position.
2.Turn off all electric power to the appliance if service is to be performed.
Shutting Off Burner Only (pilot stays lit)
Turn control knob clockwise 
to the PILOT position.
MANUAL LIGHTING PROCEDURE
1.Remove front panel (see Figure 7, page 8).
2.Follow steps 1 through 5 under Lighting Instructions, page 13.
3.With control knob pressed in, strike match. Hold match to pilot until pilot lights.
4.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 8, under Lighting Instructions, page 13.
5.Replace front panel.
OPERATING HEATER
THERMOSTAT MODELS
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire de- partment.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
For
.
.com
107887
