OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if
One Piece
Log Set
Middle
Section at
Bottom of Log
Set
Burner
Chassis
I
H
| O |
NO | FF |
Figure 22 - Installing One Piece Log Set
flame contact any log. If so, repo- sition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Burner Ports
One Piece Log Set
1.Place
IMPORTANT: Make sure log does not cover any burner ports.
2.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 24).
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.
Figure 23 - Installing One Piece Log Set (Top View)
Notches
Screws for
Mounting Screen
Figure 24 - Installing Fireplace Screen
105269 | 13 |