| Part No. T0264, Rev A |
Installing the Daughtercard | April, 2003 |
Page 2 of 2 |
Installing the Daughtercard
Vanguard 340 and 342
Step |
| Action | ||
|
| |||
1 | Unplug the power cord from the primary power source and remove | |||
| interface and power cables. |
|
| |
|
| |||
2 | Remove the two screws on either side of the chassis at the rear of the unit. | |||
|
| |||
3 | Use the handle on the right side of the rear panel to carefully slide out the | |||
| motherboard. Exercise extreme care, when sliding the motherboard out, to | |||
| prevent components mounted to the underside of the board from being | |||
| knocked off. |
|
| |
|
| |||
4 | Place the motherboard on a (static free) clean flat surface. | |||
|
|
| ||
5 | If you are... | Then... | ||
|
|
| ||
| Adding a daughtercard | Connect the | ||
|
|
| the motherboard. | |
|
|
| ||
| Replacing an existing daughtercard | a) Remove the daughtercard | ||
|
| Note | mounting screws that attaches the | |
|
| |||
|
| daughtercard to the board. | ||
|
| When replacing an older version | ||
|
| b) Unscrew the two rear panel | ||
|
| daughtercard into a newer unit, | ||
|
| remove the old daughtercard header, | coverplate screws. Unplug the | |
|
| and insert the newer | existing daughtercard. If no | |
|
| interface header (product code | daughtercard is installed, remove | |
|
| the metal blanking plate. | ||
|
| Connect the shorter header pins | c) Align the standoff on the | |
|
| from the | ||
|
| motherboard with the hole on the | ||
|
| the motherboard. | ||
|
| new daughtercard. | ||
|
|
| ||
|
|
| ||
6 | Push the daughtercard down into the connector being careful to align the | |||
| pins. Do not apply excessive pressure when you push the daughtercard into | |||
| the connector, or you may damage the card. | |||
|
| |||
7 | Fasten the screw that attaches the daughtercard to the motherboard, then | |||
| fasten the two rear panel coverplate screws. Daughtercard replacement/ | |||
| addition is complete. |
|
| |
|
| |||
8 | Carefully slide the motherboard into the card guides within the opening. | |||
| Exercise extreme care when sliding the motherboard in, to prevent | |||
| components mounted to the underside of the board from being knocked off. | |||
|
| |||
9 | Tighten the screws on both sides of the chassis. Be sure the screws are | |||
| snug. |
|
| |
|
| |||
10 | Reconnect the cables and power cord. | |||
|
|
|
| |
11 | Power on the unit. |
|
| |
|
|
|
|
|
|
|
|
|
|
