
Installing the Rack Model in a Rack Enclosure
Installing the Rack Model | in | a Rack | Enclosure |
During | this | procedure, you must install parts on the rack enclosure and | |
This process | can | be divided into three parts: |
Ÿ Preparing the server
Ÿ Preparing the rack enclosure
ŸInstalling the server into the rack enclosure
|
| Before | you | begin |
|
|
|
|
Ÿ |
|
|
|
| ||||
Read | “Electrical Safety” | on | page 41 and “Handling | |||||
|
| on page 42, and the safety information in your rack enclosure | ||||||
|
| documentation. |
|
|
| |||
Ÿ | Turn | off the server, if | it | is on. |
ŸRefer to your rack enclosure documentation for additional informatio preparing the rack.
Preparing the Server
In this section, you will use the following parts:
Ÿ | One | cable | arm bracket |
Ÿ | The | inner | slide from two slide bracket assemblies |
Ÿ | 6 | short screws (M4 by 5 mm) |
5
k32 kg (70.5 lbs) | k55 kg (121.2 lbs) |
CAUTION:
Use safe lifting practices when lifting your machine.
Attention :
To avoid damage to internal components, use only the
96 Netfinity 5000 Server Hardware Information and Procedures