Installing or Removing Internal Drives
Installing or Removing | a | Drive | in | Bay | C | (Diskette Drive) |
|
|
| ||||||
| This | section gives |
| the | procedure | for | installing | or removing a diskette | |||||||
|
|
| Before | you | begin |
|
|
|
|
|
|
|
|
|
|
| Ÿ |
|
|
|
|
|
|
|
|
|
| ||||
| Read | “Electrical | Safety” on | page 41 and | “Handling | ||||||||||
|
|
| on | page 42. |
|
|
|
|
|
|
|
|
| ||
| Ÿ | Read | the | documentation that | comes | with | the | option. | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To remove a drive in bay C:
1. Locate the
2. Press the tab against the drive and hold it there while pulling t
3. Disconnect the diskette drive cable and power cable from the dri
4. If you want to install or remove any other options, do so now. Oth “Completing the Installation” on page 76.
To install a drive in bay C:
1.If you have not done so, remove the server cover and front bez “Preparing to Install Options” on page 43.
2.Using the instructions that come with the drive, together with the check that any switches or jumpers on the drive are set correctly settings if necessary. For information about termination requirements, s “Termination Requirements” on page 59.
3.Insert the drive into the bay.
a. Position the drive so that the connectors face the rear of th diskette eject button is toward the outside of the server.
b. Connect the diskette drive cable and power cable to the drive.
Note: If | you | have | difficulty connecting a cable, turn the cable |
over | and | try | again; cable connectors are keyed to connect |
way. |
|
|
|
62 Netfinity 5000 Server Hardware Information and Procedures
