Ethernet Controller Messages

pnt0-12 Device failed checksum test!

Explanation: The driver cannot find an Ethernet controller.

Action: Verify that the PCI Ethernet device type is set to the default (enabled) p

Configuration/Setup utility programs (see “PCI

Bus

Control”

on page 29). If the

Ethernet

enabled,

go to

“Diagnostic Test

Programs” on

page 111 to

run

the

diagnostic

utility.

 

 

 

 

 

 

 

 

 

 

 

 

pnt0-13

add_intr_handler

failed!

Interrupts

already enabled.

 

 

 

 

 

 

 

Explanation:

The

interrupt

request (IRQ) that

was

specified,

or

the IRQ that was fo

other devices

in

the server.

 

 

 

 

 

 

 

 

Action: Modify your hardware settings.

Run the NETCONFIG program to match the hardware settings.

pnt0-14 Cannot locate hardware.

Explanation: The SunSoft Solaris driver cannot find any Ethernet controller.

Action: Verify that the PCI Ethernet device type is set to the default (enabled) p Configuration/Setup utility programs (see “PCI Bus Control” on page 29). If the Ethernet enabled, go to “Diagnostic Test Programs” on page 111 to run the diagnostic utility.

pnt0-15 No more devices to open.

Explanation: The SunSoft Solaris driver cannot find any more Ethernet controllers.

Action: Verify that additional Ethernet adapters are present or replace the Ethernet respond. If the problem persists, go to “Diagnostic Test Programs” on page 111 to run utility.

pnt0-17 Device fault...Reset initiated!

Explanation: The SunSoft Solaris driver has been reset due to a device fault.

Action: Verify that additional Ethernet adapters are present or replace the Ethernet respond. If the problem persists, go to “Diagnostic Test Programs” on page 111 to run utility.

pnt0-19

IRQ found

for

PCnet

hardware

does not match space.c (or pnt.conf)!

 

 

Explanation:

This

is

a

warning

message referring to the interrupt

request (IRQ)

that t

Solaris

driver

found in the system.

 

 

Action:

Ignore

this

message

if you are sure that this is what

you want to

do. Othe

NETCONFIG

program

to

match the

hardware settings.

 

 

pnt0-20

add_intr_handler

failed!

Unknown

interrupt

type.

Explanation:

The

interrupt

request

(IRQ) that was specified, or the IRQ that was fo

other devices in the server.

 

Action:

Modify

your

hardware

settings.

Run the NETCONFIG program to search for another Ethernet controller.

pnt0-21

add_intr_handler failed!

Out of range

interrupt

number.

Explanation:

The

interrupt

request

(IRQ)

that was specified, or the IRQ that was fo

other devices

in the server.

 

 

Action: Modify your hardware settings.

Run the NETCONFIG program to search for another Ethernet controller.

pnt0-22

add_intr_handler

failed!

Out

of range

IPL.

Explanation:

The

interrupt

request

(IRQ) that was specified, or the IRQ that was fo

other devices

in

the

server.

 

Action: Modify your hardware settings.

Run the NETCONFIG program to search for another Ethernet controller.

Chapter 6. Solving Problems 141

Page 149
Image 149
IBM 5000 Pnt0-12 Device failed checksum test, Pnt0-13, Pnt0-14 Cannot locate hardware, Pnt0-15 No more devices to open