IBM 5000 manual Installing the Server in the Rack Enclosure, To install Server Into Rack Enclosure

Installing the Rack Model in a Rack Enclosure

Installing the Server in the Rack Enclosure

In this section, you will use the following parts:

Ÿ	Four	long	screws (M6	by 16 mm)
Ÿ	Two	cage	nuts
Ÿ	One	cable-management		arm

ŸCable ties

To install	the server		into	the	rack	enclosure:
1. If	you	have	not	done		so already, install a cage nut in each fro
the	marked	positions,			as	shown.

2. Position

the

Netfinity

5000

server

horizontally,

with

the

3.5-inch

drive

the

top.

3. Align

the

inner

slides

on the sides of the server with

the

slide

the

server

onto

the

outer slide, until the slide rails

click

into

p

Note:

When

the

rack

model

is fully extended,

safety

latches

on

th

lock into place. This prevents

the server

from

being

accidentally

out

too far and

dropped. To

release the

safety

latch,

press

4.Press the safety latches and slide the rack model about halfway enclosure.

102 Netfinity 5000 Server Hardware Information and Procedures