IBM 5000 manual Preparing a Rack Model, Preparing to Install Options

Preparing to Install Options

Preparing a Rack Model

Before you begin

Read the documentation that comes with the rack enclosure for additi safety and operating information.

The hard disk drives in Netfinity 5000 server are hot-swappable. If you installing only a hard disk drive (bays 1 through 5), go directly to Removing Internal Drives” on page 56. Otherwise, continue with the followin steps.

1. If you have a modem or fax machine attached to the server, di telephone line from the wall outlet and the server.

Note: If you are in the United Kingdom, you must perform this ste disconnecting the power cord.

6

CAUTION:

The Power-on switch on the

front

of the server does

not

turn

off

the

electrical

current

supplied

to

the

server.

The

server

also might

have

more

than

one

power

cord.

To

remove

all

electrical

current

from

the

server,

ensure

that

all

power

cords

are

disconnected

from

the

power

source.

2. Unplug

all

power

cords

(cables)

from

electrical outlets, and then d

other

cables from

the

back

of

the

server.

3. Remove

the

screws from

the

brackets

on

either

side

of the serve

them

aside.

4. Pull the rack model out of the rack enclosure until both slide rail

Note: When the server is in the locked position, you can easily re cables on the back of the server.

46 Netfinity 5000 Server Hardware Information and Procedures