SCSI Messages
SCSI Messages
The | following table | lists | messages | that | reflect problems with the | SCSI |
a SCSI device. |
|
|
|
|
| |
Note: | If your server does not have a hard disk drive, ignore | any | ||||
| indicates that | the | BIOS is | not | installed. |
|
SCSI Message Table
You will get these messages | only when | running the SCSISelect program. Fo | ||||||||||||
more information, | see | the | documentation | that | comes | with | the SCSISelect | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SCSI Messages | Description |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||
All | One |
| or more of the following might | be | causing the problem: | |||||||||
| Ÿ | A | failing SCSI device (adapter, drive, controller) |
|
| |||||||||
| Ÿ | An | improper | SCSI configuration | or | SCSI | termination | jumper | setting | |||||
| Ÿ | Duplicate | SCSI | IDs | in | the | same | SCSI | chain |
|
|
| ||
| Ÿ | A | missing or improperly installed SCSI terminator |
|
|
| ||||||||
| Ÿ | A | defective | SCSI | terminator |
|
|
|
|
|
| |||
| Ÿ | An | improperly | installed | cable |
|
|
|
|
|
| |||
| Ÿ | A | defective | cable |
|
|
|
|
|
|
| |||
| Action: | Verify | that: |
|
|
|
|
|
|
|
| |||
ŸThe external SCSI devices are turned on. External SCSI devices must be
turned on | before | you turn on the system. |
Ÿ The cables | for all | external SCSI devices are connected correctly. |
ŸIf you have attached an external SCSI device to the server, the
termination is set to automatic.
ŸThe last device in each SCSI chain is terminated correctly. See “Ins Removing Internal Drives” on page 56 for more information about SCSI termination.
ŸThe SCSI devices are configured correctly.
If the above are correct, run the diagnostic tests for additional in failing device. If the error recurs, have the system serviced.
Chapter 6. Solving Problems 135
