IBM 5000 manual Installing, a Rack Enclosure

		Installing	the	Rack		Model in	a Rack Enclosure
5. Attach	the	cable-management	arm		to	the	cable-arm bracket, using two
(M6 by	16	mm) screws.

6. If	you have	not	done	so	already, attach	the	cable-management ar
as	described	in	steps	5a	on page 100 and	5b on	page 101.

7.Attach the monitor, keyboard, and power cables to the correspondi connectors on the server. Refer to the rack enclosure documentatio instructions.

8. Attach the cables to the cable-management arm using the cable tie

Note: Be sure to route the cables above the top edge or below edge of the cable-management arm, to avoid overstressing the

Chapter 5. Installing a Server in a Rack103Enclosure