
Failover for Redundant Ethernet
identical. Most applications and protocols that are currently installed Ethernet system can be seamlessly migrated to a Fast Ethernet system. of the equivalence of the two types of Ethernet, mixed Ethernet and systems also can be designed and implemented.
The | bandwidth | required | at each | workstation connected | to | a | server | is | ||||||||
less | than | the | bandwidth | required | at | the | server. This | is | because | t | ||||||
have | to handle the bandwidth of | multiple | workstations | at | the | same |
| tim | ||||||||
requirements | of | this | type | o | ||||||||||||
mixed Ethernet and Fast Ethernet network. This mixed network consists | of | |||||||||||||||
standard | Ethernet connections | at the | workstations and | Fast | Ethernet | conn | ||||||||||
the | servers. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
The | Ethernet controller | is | a | PCI | device, | and is therefore, a Plug | a | |||||||||
You | do not have to set | any | jumpers | or | configure the | controller | for | |||||||||
system before | you use | the | Ethernet | controller. |
|
|
|
|
|
|
|
Notes:
1.For troubleshooting information, see “Troubleshooting the 10/100 Mbps Ethernet Controller” on page 149.
2.The Ethernet controller supports the operating systems that your s supports. To find out which operating systems your server supports, following World Wide Web address:
http://www.pc.ibm.com/us/compat/
If you | need additional Ethernet | connections, | you can install an Etherne |
such as | an IBM 10/100 Ethernet adapter. Review your | ||
documentation for any additional | configuration | requirements. |
Note: If you are installing an IBM 10/100 Ethernet adapter, be sure Ethernet controller diagnostics and record the Ethernet controller configuration information before you install the adapter.
Failover for Redundant Ethernet
Your Netfinity 5000 server has | an integrated | Ethernet | controller. The | I | |||
10/100 Fault Tolerant Adapter is an optional redundant | network | interface | |||||
adapter) that you can install in your Netfinity 5000 | server. | If | you | i | |||
adapter and connect it to the same logical segment | as | the | primary | E | |||
controller, you can configure the serverfailoverto functionsupport. aYou can |
|
| |||||
configure either the integrated Ethernet controller | or | the | NIC | adapt | |||
Ethernet controller. In failover | mode, if the | primary Ethernet controlle |
link failure, all Ethernet traffic associated with it is switched to (secondary) controller. This switching occurs without any user interventi Applications with active sessions do not experience any data loss. Wh primary link is restored to an operational state, the Ethernet traffi switches back to the primary Ethernet controller.
Chapter 3. Configuring Your Server33