
Using the SCSISelect Utility Program
5.Check theGrouping box. This will show the possible combinations for redundant pairs.
6.Select the adapter pair you want OKand. Notthen thatselecthe integrated
Ethernet controller is located at PCI bus 0, slot 9.
7. SelectClose to exit from the Network setup.
When you restart the server, the failover function will be in ef
If a failover occurs, a message is written to the NT Event Viewer
instrumentation | code | for the integrated Ethernet controller is active |
was run), a | message is generated also. |
Configuring Failover on IntraNetWare
1. Install the | redundant NIC adapter | according to the instructions p |
the adapter | and in “Installing or | Removing Adapters” on page 50. |
2. Load the device driver by using the following command:
LOAD d:\path\PCNTNW.LAN PRIMARY=x SECONDARY=y
whered | andpath are the drive | and | path | where the driverx and is locat |
y are | the PCI slot numbers | where | the | redundant pair is located. |
The slot number associated with the integrated Ethernet controller
depending | upon | the configuration | of the Netfinity 5000 server. To | de | ||||
the slot | number, load | the | driver with | no | parameters. The driver | w | ||
available | slot | numbers. | The | slot | number | that | is greater that 10000 | w |
slot number of the integrated Ethernet controller. When the slot num integrated Ethernet controller is determined, reload the driver wit appropriate parameters.
3. When the driver is loaded, bind it to a protocol stack.
The failover function is now enabled. If a failover occurs:
Ÿ A message is generated to the operating system console.
ŸThe custom counters for the device driver contain variables that
state of | the failover | function | and | the location of the redundant |
use the | NetWare Monitor | to view | the | custom counters. |
Using the SCSISelect Utility Program
Your server comes with a
You can use the SCSISelect Utility program to:
Ÿ | View and | change | the device | configuration |
Ÿ | Perform a | format or | verify the media on a SCSI hard dis |
Chapter 3. Configuring Your Server35