♦If you are using TCP/IP, note your computer’s IP address. The print server needs to be on the same IP segment as the other nodes on your network in order to communicate.
♦Make sure you have a good signal between your computer and the access point.
I n s t a l l i n g t h e S o f t w a r e
The following operating systems are supported: Microsoft Windows 95, 98, ME, NT 4, 2000, and XP.
Follow these steps to install the Monarch® NetMgr software and configure the print server. You can also download the utility from our Web site.
1. Insert the Monarch® Tabletops Documentation
2. Click on the Monarch NetMgr folder, then click on Setup.exe.
3. Follow the
You are prompted to enter a View name. Then you can either select the protocol and filter settings, or “Automatically create a view with default settings.”
4. Click Finish to begin searching for print servers. NetMgr gets the information from the print server(s) and lists the sever name, IP address, and hardware (Ethernet) address. It might take a minute or two for the printer server to show up, especially if you have a large wireless network. The default name of the print sever is PXRxxxxxx, where xxxxxx is the last 6 digits of the Ethernet address (for example, PXR08B2C7).
Note: If you do not see the print server in the list, hold down the test button on the back of the print server for more than 5 seconds to reset it to factory defaults and try the search again. If you still do not see it, see Chapter 5, “Troubleshooting.”
5. When you see the print server you need to configure in the list, highlight it and click the Configuration tool.
