5. To view the current wireless settings, type sh en (show wireless settings) or sh nw (show network settings) and press Enter:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ENG4121
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
6. To show the current IP settings, type sh ip (show TCP/IP settings) and press Enter.
IP is enabled |
|
|
|
|
|
|
IP address | 10.110.10.21 |
| Boot tries |
| 3 | |
Subnet mask | 255.255.0.0 Boot method AUTO |
| ||||
IP Gateway | 10.110.110.254 | Max window |
| 10240 | ||
(via DHCP 10.110.1.1) |
|
|
|
| ||
LPD banner | disabled | Timeout | 0 | min | ||
LPD retries are disabled | Keepalive | 1 | min | |||
Service Port | TCP port |
|
|
|
| |
PXR1E8580_X1 | X1 | 9100 |
|
|
|
|
7. To change the SSID, type set en ssid testsystem and press Enter.
8. To set the IP address, type set ip ad 10.10.302.192 and press Enter.
9. To set the subnet mask, type set ip sub 255.255.255.0 and press Enter.
10. Type INIT and press Enter to save the settings and initialize the unit.
11. Type EXIT to exit Telnet.
See the following section for a list of the most frequently used commands.
