V027_Rapide XL_aw 25/10/05 4:34 pm Page 12
Belt or brush removal |
| Belt or brush removal |
and replacement |
| and replacement |
4 | 5 | 1 |
24
1.Loop the belt around the rear shaft.
2.Loop the top of the belt above the small pulley and the bottom of the belt around the lower small pulley.
3.Feed the entire belt over the first large pulley.
4.Loop the belt around the front large pulley and rotate the front brushbar forward until the
belt is in place.
Note: Make sure the entire belt stays on top of the first large pulley by lightly placing a finder on top to guide it.
Return the nozzle cover to the original position.
Secure by replacing the two (2) screws.
Remove the screw that holds the brushbar in place.
2 | 3 | 4 |
25
Tilt cleaner off the carpet. Grasp the brush bar and pull the right side of its chamber.
Tilt the brushbar down to the ground and remove the silver cap. Slide the worn brushbar out of the cleaner.
To install a new brushbar. Feed the brushbar through the opening until the screw plate and screw hole are lined up (as above).
Note: The black cap behind the silver screw plate will be through the hole.
Replace the silver cap to right side of the brushbar. Lift the brushbar up and align with the brushbar chamber. Push the screw plate towards the screw hole until the flush and replace the screw.
