V027_Rapide XL_aw 25/10/05 4:33 pm Page 2
Putting your cleaner together
4 | 5 | 6 |
4
Feed the cord through the slots on the back of the handle and push into place.
Place a nut into the recess in the back of the upper handle. While holding the nut in place insert one of the large screws through the front of the upper handle and tighten.
Repeat the process with the second screw.
Remove the backing tape from the screw cover and press into place.
Clean water tank | Tool storage |
1 | 2 | 1 |
5
Note: Make sure the cleaning solution tank is resting in place with the solution tube pressed fully into tube opening.
Line up the grooves of the clean water tank with the support posts inside the handle. Tilt the top of clean water tank inward and push until it locks into place.
To install the tool caddy, line up the tabs of the tool caddy storage with round tabs on the back of the handle (above quick cord clip).
