General Care & Cleaning (cont’d)
Models with Coil Surface Elements
Porcelain Enamel Cooktop Cleaning Instructions
Do not use a cooktop cleaner on a hot cooktop. The fumes can be hazardous to your health, and can chemically damage the cooking surface.
Before cleaning the surface cooktop, be sure the controls are turned to OFF and the cooktop is cool.
DO NOT use commercial oven cleaners on the exterior surfaces including rangetop and door frame.
Correct and consistent cleaning is essential to maintaining your porcelain enamel cooktop. If food spills and grease spatters are not removed, they may burn onto the surface of the cooktop and cause permanent discoloration.
Daily Cleaning
For normal soil:
1.Allow cooktop surface to cool.
2.Wipe off spills and spatters using a clean paper towel or a clean cloth with warm, soapy water.
3.If needed, use a Blue
4.Be sure to rinse off the cleaners or the porcelain may become damaged during future heating.
For heavy, burned-on soil:
1.Allow cooktop surface to cool.
2.Use a soap filled scouring pad with warm water or cover heavily soiled spots with a solution of clear water and ammonia. Scour gently. Rinse and wipe dry with a clean cloth.
3.If any soil remains, apply a few drops of a recommended cooktop cleaning cream on the spots and rub gently using a clean damp cloth or scouring pad. Buff with a dry cloth until all soil and cream are removed. Frequent cleaning with the cooktop cleaning cream leaves a protective coating which helps in preventing scratches and abrasions.
For sugary spillovers:
Sugary spills can chemically damage your cooktop surface. Therefore, you must begin cleaning the spills while the cooktop is still hot. Use caution when following the steps below.
1.Turn off all surface units and remove all pans immediately.
2.Put on an oven mitt, wipe up carefully or move hot spills away from the element area with a clean damp cloth.
3.Allow the cooktop to cool. Follow the instructions above for heavy,
SURFACES | CLEANING AGENTS | INSTRUCTIONS |
|
|
|
Porcelain enamel (cooktop, | Mild cleaners or Blue | Use a damp sponge or dampened soap pad, rinse |
surface under cooktop) | pose No Scratch Scrub Sponge | and dry. |
|
|
|
Broil Insert | Hot, soapy water or cleaner | Use a clean soapy, dampened cloth or paper towel, |
Control Panel | cream. | remove soil and dry. Do not use abrasive products. |
|
|
|
|
|
|
Coil Surface Element
To Remove and Replace Surface Elements and Drip Bowls
ATTENTION: Never leave lids on the coil elements as they could be permanently damaged if the coil is turned on by accident.
Prior to cleaning the drip bowls make sure the coil elements are cold and the control knobs are turned to OFF
Coil elements clean themselves when they are turned on.
Coil elements and drip bowls are removable and allow you to clean the drip bowls. To remove a coil element, push against the front edge and lift element up and out.
To clean by hand, wash the drip bowls in hot sudsy water. For hard to remove spots, use nylon scrubber with soap. Rinse and dry while still warm.
Never immerse coil elements in water.
Be careful not to bend terminal ends when replacing elements after cleaning.
22
