VEC401_Manual_030705 3/9/05 2:45 PM Page 10
TROUBLESHOOTING GUIDE
No function using DC power cord | 1. | Check power cord connection to |
|
| vehicle. |
| 2. | Check if vechicle ignition switch is on. |
| 3. | Check fuse in DC accessory plug. |
|
|
|
No function using AC power cord | 1. | Check AC power source. |
| 2. | Check AC/DC adapter connection. |
|
|
|
No AC output from inverter | 1. | Check DC power cord connection. |
| 2. | Make sure power switch is on. |
| 3. | Check for excess load — remove load, |
|
| turn unit off, then on again. |
| 4. | Check that unit is not overheating — |
|
| make sure the vent on the bottom is not |
|
| blocked. Turn the unit off for five minutes, |
|
| then turn it back on. |
| 5. | Check for sufficient vehicle voltage. |
|
| If voltage is low, charge the vehicle |
|
| battery. |
|
|
|
No audio | 1. | Check audio cable connection. |
| 2. | Check audio signal source. |
| 3. | Adjust the volume control. |
|
|
|
No video | 1. | Check video cable connection. |
| 2. | Check video signal source. |
| 3. | Adjust brightness and color. |
|
|
|
Distorted or poor video | 1. | Select zoom to proper format. |
| 2. | Adjust brightness, contrast, color |
|
| and tint. |
|
|
|
SPECIFICATIONS
Input Voltage: | 12 volt DC |
Input Current: | 10 amps |
Low Battery Voltage |
|
Indicator: | 10.5 volts |
AC Adapter: | 120 volt AC in / 12 volt DC 1500 mA out |
AC Output: | 120 volt* AC, 60 Hz, 100 watts |
AC Output Waveform: | Modified sine wave |
Video Input Signal: | |
Video Output: | 1.0 V P/p NTSC composite |
Audio Input: | 2 channel stereo |
Audio Output: | 2 channel stereo |
Audio Power: | 2 watts / channel |
Monitor Resolution: | 1440(H)x 234(V) |
Display Format: | 16:9 Wide Screen or 4:3 Regular |
*AC 120 volt output power varies depending on DC input and variable load conditions.
10 | 11 |
