TV SCREEN USER INTERFACE FOR OPTIMIZATION | Digital DrivePLUS User Interface Manual |
Figure 15: System Response Screen with
8)You can watch the subwoofer smooth its frequency response by adjusting the parametric EQ filters on the System Response screen.
9)When
Running
The next level up in the Digital DrivePLUS EQ optimization methods is
1)Set up the microphone as in the
2)Connect your subwoofer to your TV video input as described above in the Make Video Connection between TV and Subwoofer section.
3)Make sure the subwoofer and your audio system are both on.
4)Place the Digital DrivePLUS Sweep Tone CD into your disc player and press play.
5)Once the sweep tone starts to play, adjust the receiver or processor output level to about the level of a
6)Press and hold EQ on the remote until
The
•
•You decide to quit, and press RESET on the remote. You exit back to the Introductory screen, you don’t see the
•You move the cursor off the AUTO field (in which case the field automatically reverts to
•The frequency response level is too high (peaks over 87 dB) or too low (average level below 70 dB).
•The Sweep Tone CD stops playing.
7)The Digital DrivePLUS subwoofer not only adjusts the Setup preset EQ filter levels as you watch, but it also adjusts the subwoofer level, crossover, slope, and phase during the
8)You can also watch the status messages during the process in the upper left hand corner of the TV screen.
[ 32 ]
