TV SCREEN USER INTERFACE FOR OPTIMIZATION | Digital DrivePLUS User Interface Manual |
9)When
10)While the subwoofer is rebooting, shut off the Sweep Tone CD and remove it from the player.
Figure 16: System Response Screen Auto EQPLUS Mode
Running Manual EQ Optimization– Adjust it to Your Liking
In some particularly problematic rooms, it may be necessary to employ even further adjustment than the
1)Set up the microphone, subwoofer and Sweep Tone CD as in the
2)Connect your subwoofer to your TV video input as described above in the Make Video Connection between TV and Subwoofer section.
3)Set the system playback volume level as in the
4)Push 1 – 2 – 3 – 4 – 5 on the remote. If you are already on the System Response screen, select the MANUAL option in the EQ MODE area.
5)Watch the status messages for SYNCING.
6)When the status message says SYNCED, start adjusting the subwoofer parameters. Do not attempt to adjust any settings until the status message says SYNCED. SYNCED means the subwoofer has synchronized its frequency measurement with the frequency of the sweep tone being played through your audio system. An indication of not being synced is that you raise or lower filter slider and the response curve moves at another frequency. Also, the marker in the sweep tone (a small pop) occurs anywhere but at the top of the graph.
7)Click Mute. You can now see the low frequency character of the satellites so that you can make a judgment about their
8)Click Mute again to restore the subwoofer to playing.
In
9)Adjust the preset parameters.
10)Adjust the parametric filter EQ parameters.
11)Save your changes as described in the Save Settings section.
[ 33 ]