![](/images/new-backgrounds/1006034/603413x1.webp)
locations when possible. When using a pair of Velodyne subwoofers in stereo, it is preferable to place each subwoofer by the satellite of the same channel.
Caution!
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to sources of heat such as furnace registers, radiators, etc. Do not place the unit near sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power cord should be routed in such a way that it will not be walked on, pinched, or compressed in any way that could result in damaging the insulation or wire.
Regardless of where you install your Velodyne subwoofer, it must remain in an upright position (woofer facing forward). Using, shipping, or otherwise storing the subwoofer in any other position for an extended period of time may result in damage to the unit not covered by warranty.
The
Subwoofer outputs
The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the
To bypass the subwoofer's internal crossover when the unit is being fed a low pass signal from another crossover, simply locate the switch marked
Figure 1: Installation using line-level inputs
POWER
VOLUME CROSSOVER
CAUTION!
Protection circuitry
Your new subwoofer is equipped with special protection circuitry to provide maximum performance with greatest reliability.
FROM AMPLIFIER | TO SPEAKERS |
RIGHT | LEFT | RIGHT | LEFT |
MAIN OUTPUTS
RIGHT LEFT
Serial # Label
MADE IN USA
LEFT~
RIGHT
IN OUT
AMPLIFIER
MAIN | INPUTS | MAIN OUTPUTS |
RIGHT | LEFT | RIGHT LEFT |
The unit is protected against: 1)Overdriving the speaker or amplifier. 2)Overheating the amplifier. 3)Excessive drop in power line voltage.
TO SATELLITE SPEAKERS
continued. . .
9 | ☞ | 6 | ☞ |
|
|
|
|