Velodyne Acoustics VX-10 owner manual Speaker Line-levelConnections, Subwoofer Outputs

Speaker Line-level Connections

When installed in this fashion the satellite speakers will be crossed over at 80Hz. This removes the lower bass from your amplifier and speakers, enabling them to do a better job reproducing high frequencies. By utilizing this method you will have a bi-amplified system, gaining improved power and headroom for your system.

Subwoofer Outputs

The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the built-in crossover. Many home theater processors/receivers (Dolby Digital, DTS, THX) have a "subwoofer out" jack that is internally filtered and designed to be used with a powered subwoofer. In some installations, it may be beneficial to have a steeper ultimate crossover slope. To do this, you can use both your processor's crossover and the one internal to the Velodyne sub.

(Refer to Figure 2a and 2b, Page 11 and 12 for connection diagram)

Figure 1. Rear panel inputs, output and operational layout.

8☞