2
PLACEMENT INFORMATION
• Do not use this unit in places which are
extremely hot, cold, dusty, or humid.
• Do not restrict the air flow of this unit by
placing it somewhere with poor air flow, by
covering it with a cloth, or by placing it on
bedding or carpeting.
SAFETY INFORMATION
• When connecting or disconnecting the AC
cord, grip the plug and not the cord itself.
Pulling the cord may damage it and create a
hazard.
• When you are not going to use the unit for a
long period of time, disconnect the AC cord.
CONDENSATION INFORMATION
• When left in a heated room where it is warm
and damp, water droplets or condensation
may form inside the unit. When there is
condensation inside the unit, the unit may
not function normally. Let the unit stand for
1-2 hours before turning the power on, or
gradually heat the room and let the unit dry
before use.
WARNING: Changes or modifications to
this unit not expressly approved by the
party responsible for compliance could
void the user authority to operate the
equipment.
NOTE: This equipment has been tested and
SAFETY PRECAUTIONS* SEE REAR OF UNIT FOR GRAPHIC SYMBOLS *
The exclamation point within a triangle
alerts you to the presence of important
operating, maintenance and servicing
instructions in this user’s manual.
The lightning flash with an arrowhead
within a triangle alerts you to uninsulated
dangerous voltage within the product's
enclosure that could cause an electric
shock.
WARNING: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED PERSONNEL.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE. DO NOT PLACE OBJECTS FILLED
WITH LIQUIDS ON OR NEAR THIS UNIT.
AVIS RISQUE DE CHOC ÉLECTRIQUE NE
PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: DANGER OF EXPLOSION IF BATTERY
IS INCORRECTLY REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE.
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Shielded cables must be used with this unit to
ensure compliance with the Class FCC limits.
The symbol for Class II
(Double lnsulation)
WARNING: Should any problems
occur, disconnect the AC cord and
refer servicing to a qualified
technician.
PLV16151S1 VEN - WM CANADA.pmd 1/10/2007, 5:06 PM2