Venturer PVS7980 owner manual Maintenance, Accessories, Getting Started, To Change Remote Battery

Models: PVS7980

1 20
Download 20 pages 33.91 Kb
Page 5
Image 5

MAINTENANCE

Cleaning THE Disc

A defective or soiled disc inserted into the unit can cause sound to drop out during playback. Handle the disc by holding its inner and outer edges.

Do NOT touch the surface of the unlabeled side of the disc.

Do NOT stick paper or tape on the surface.

Do NOT expose the disc to direct sunlight or excessive heat.

Clean the disc before

playback. Wipe the disc from the center outward with a cleaning cloth.

NEVER use solvents such as benzine or alcohol to clean the disc.

Do NOT use irregular shaped discs (example:

heart shaped, octagonal, etc.). They may cause malfunctions.

Cleaning the unit

Be sure to turn the unit off and disconnect the AC power cord before maintaining the unit.

Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe with a dry cloth.

Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. Do NOT use compressed air to remove dust.

Important Note

Before transporting the unit, remove the disc from the disc compartment.

Accessories

Please LOCATE the INCLUDED accessories.

To order replacement units, visit http://www.venturer.com

Remote Control (with battery)

x 1

DC-AV Cable

x 1

Car Power Adapter

x 1

Straps

x 2

GETTING STARTED

Using the Remote Control

Point the remote control at the REMOTE

SENSOR located on the unit.

When using this unit in bright light, the infrared

REMOTE CONTROL SENSOR may not work properly.

The recommended effective distance for using the remote control is about 16 feet.

TO CHANGE REMOTE BATTERY

1. Open the battery door.

2. Insert one CR2025 (3V) size battery.

CAUTION:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Remove the PVC sheet before operating the Remote Control.

BATTERY REPLACEMENT

When the battery becomes weak, the operating distance of the remote control will be greatly reduced and you will need to replace the battery.

Note:

If the remote control is not going to be used for a long time, remove the battery to avoid damage caused by battery leakage corrosion.

When discarding battery, environmental problems must be considered and local rules of laws governing the disposal of this battery must be followed strictly.

WARNING:

Do not dispose of batteries in a fire. They may leak and/or explode.

The battery should not be exposed to excessive heat such as sunshine, fire or the like.

E - 5

811-798191W012.indd 5

4/1/2008 5:00:57 PM

Page 5
Image 5
Venturer PVS7980 owner manual Maintenance, Accessories, Getting Started, To Change Remote Battery, Battery Replacement