Verbatim K7VT4-8X, K7VT4-4X user manual Connectors, IDE2

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over these connectors.

Connector					Figure					Description
FDD connector
(33-pin FLOPPY1)									Red marking
(see p.7/p.8 item 13)			Pin1			FLOPPY1
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)							Secondary IDE connector (Black)
(39-pin IDE1, see p.7/p.8 item 8)							(39-pin IDE2, see p.7/p.8 item 7)
	PIN1	IDE1						PIN1	IDE2
connect the blue end									connect the black end
	to the motherboard								to the IDE devices
				80-Pin ATA 100/133 cable

Note: To optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black).

USB 2.0 header (9-pin USB45)

(see p.7/p.8 item 16)

USB_PWR

P-5

P+5 GND

DUMMY

1

GND

P+4

P-4

USB_PWR

ASRock I/OTM provides you four default USB 2.0 ports on the rear panel. If the USB 2.0 ports on the rear panel are not sufficient, you may use this USB 2.0 header to attach two additional USB 2.0 ports.

Infrared module connector (5-pin IR1)

(see p.7/p.8 item 17)

IRTX +5V

DUMMY

1

GND

IRRX

This connector supports an optional wireless transmitting and receiving infrared module.

Internal audio connectors (4-pin CD1, 4-pin AUX1) (CD1: see p.7/p.8 item 27) (AUX1: see p.7/p.8 item 28)

AUX-L

GND AUX1 GND

AUX-R

CD-L

GND CD1 GND

CD-R

These connectors allow you to receive stereo audio input from sound sources such as

aCD-ROM, DVD-ROM, TV tuner card, or MPEG card.

1 6