Verilux VF03 Assembly Instructions - continued, Do not touch or press, Note Do not touch material

Assembly Instructions — continued

7.Attaching the Optix® glare control filter:

•Remove glare control filter from protective plastic bag. Take care to hold filter by the edges only.

•Insert tabs on bottom of filter into opening. (Fig. 2)

•Press into place using thumb tab.

Do not touch or press

on the filter material itself.

8.Attach the ballast to the power cord. Use care to align the 4-pin plug properly. DO NOT FORCE.

The 4-pin plug was designed to fit in only one orientation (Fig. 3).

Note: Do not touch material

Fig. 2

Fig. 3

9.Plug ballast into a standard 120V 50/60Hz outlet. Turn lamp on. The green LED indicator on center of the ballast should be illuminated (Fig. 4). If the LED indicator does not illuminate, please refer to the troubleshooting section of this manual (see page 9).

10.If bulb does not illuminate instantly, please refer to the troubleshooting section of this manual.

11.Adjust lamp brightness to the desired level.

WARNING: Do not block vents on ballast. Vents are necessary for proper function of the ballast; blocking them may cause overheating of the ballast.

Vents

Fig. 4

6