Verilux VF03 manual ASSEMBLY INSTRUCTIONS cont, Note Do not, Do not touch or press, touch material

ASSEMBLY INSTRUCTIONS cont.

7. Attaching the Optix® glare control filter:

• Remove glare control filter from protective plastic bag. Take care to hold filter by the edges only.

•Insert tabs on bottom of filter into opening. (Fig. 2)

•Press into place using

thumb tab.	Note: Do not
Do not touch or press	touch material
on the filter material itself.

8.Attach the ballast to the power cord. Use care to align the 4-pin plug properly. DO NOT FORCE

– the 4-pin plug was designed to

fit in only one orientation. (Fig. 3)

Fig. 2

Fig. 3

9.Plug ballast into a standard 120V 50/60Hz outlet. Turn lamp on. The green LED indicator on center of the ballast should be illuminated. (Fig. 4) If the LED indicator does not illuminate, please refer to the troubleshooting section of this manual. (See page 9)

10.If bulb does not illuminate instantly, please refer to the troubleshooting section of this manual.

11.Adjust lamp brightness to the desired level (low-medium-high).

WARNING: Do not block vents on ballast. Vents are necessary for proper function of the ballast; blocking them may cause overheating of the ballast and increase risk of fire.

Vents

Fig. 4

6