Verilux VH04WW1 Care and Maintenance - continued, Cleaning and Replacing Filters, How to Clean

7. Care and Maintenance — continued

7.2 Cleaning and Replacing Filters

For best performance, clean filters after each use. Replace filters periodically depending on frequency of use and the amount of dirt picked up with each use.

Note: If the Power Head Mode Indicator light begins to rapidly blink RED, the airflow may be blocked. The Low Airflow Indicator (A) may also be illuminated. Clean all filters as directed below.

How to Clean

Before cleaning or replacing any filters, disconnect Power Cord from electrical outlet.

7.3 HEPA-12 Pre-Filter

The HEPA-12 Pre-Filter (B) is located outside dirt cup (C).

1.Remove the Dirt Cup (C) by lifting up on the Release Latch (D).

2.The HEPA-12 Pre-Filter (B) can be removed by pressing the Release Tab (E) and rotating away from the Dirt Cup (C).

3.Gently tap the filter on the inside of a garbage receptacle to remove excess dust and dirt. If very dirty can be cleaned with a damp cloth

(warm water) — should not be wet, just damp.

4.Replace filter by aligning Hinge Tabs (F) and rotating into place until latched into the Dirt Cup (C).

20

D

7.3

A

C

B

E F

VH04-MAN-2012_Web.indd 20 12/12/12 3:37 PM