SR-F1B SPEAKER STAND
This speaker stand is manufactured by König&Meyer GmbH(K&M) of Germany for use with TOA's
Stand: Model 213
Bracket: Model 19582
USAGE (Refer to Fig. 1.)
Extending the Stand Legs.
1 . Loosen the tripod clamp screw and extend the tripod legs by sliding the clamp ring down the length of the stand until the leg stays are horizontal, then retighten the screw.
Mounting the Speaker.
2 . Attach the stand bracket to the base of the speaker using the
supplied mounting screws and washers. (Fig. 2).
3 . After ensuring that the bracket clamp screw is loose and not protruding into the interior of the bracket, carefully place the
speaker on the stand by sliding the bracket over the end of the stand.
4 . After positioning the speaker, tighten the bracket clamp screw.
<Fig. 1>
Stand bracket |
|
clamp screw | Lock button |
| Handle clamp screw |
Height lock screw | Crank handle |
|
Adjusting Stand Height. |
|
|
5 . Loosen the height lock screw. |
|
|
6 . Loosen the handle clamp screw, then | fold out the crank handle | Tripod clamp screw |
and retighten the screw. |
| |
|
| |
7 . While holding down the lock button, adjust the speaker's height by |
| |
turning the crank handle. (Clockwise rotation raises the speaker.) |
| |
The handle cannot be turned without holding down the lock button. |
| |
After adjustment is completed, release the lock button and make sure |
| |
that the shaft is securely locked. (This can | be checked by rotating the | <Fig. 2> |
handle slightly.) |
|
|
8 . Retighten the height lock screw. |
|
|
9 . Loosen the handle clamp screw, flip | the handle back into its |
|
foldaway position and retighten the handle clamp screw. Be sure the handle is always folded up except when adjusting the height.
Height adjuster
Tripod leg
Stay
Removal After Use
10.After use, lower and detach the speaker, then collapse the stand in the reverse order of the above procedure.
Speaker Mounting Screw Storage
After the stand bracket is detached from the speaker, the speaker
mounting screws can be inserted into the threaded holes of the stand bracket for storage. (Fig. 3).
Plain washer-
Speaker mounting screw
<Fig. 3>
Speaker mounting screw
Plain washer
Threaded hole
PRECAUTIONS
Only use the stand on flat, hard ground or floor surfaces.
Avoid installing the stand near narrow passages where passers by might trip over the tripod legs. When using the stand outdoors, take care to avoid exposure to strong winds.
To reduce the chance of the stand toppling over, avoid extending the stand too high.
When there is potential for instability and the danger of a fall, be sure to secure the stand with guy wires or other devices. 
