Vermont Casting 1450 Encore WITHOUT Chimney Connector Heat Shields, Unprotected Surfaces

Encore 1450 Non-Catalytic Woodburning Stove

Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations

The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in- stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances must adhere to the guidelines stated in the clearance chart on Page 14.

Dimensions indicated are valid for installations with either 6” or 8” flue collars.

Encore: WITHOUT Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (a)		Rear (B)	Side (A)	Side (D)		Rear (E)	Corner (F)
30¹⁄₂”		25¹⁄₄”	34¹⁄₂”	21¹⁄₂”		11¹⁄₄”	14¹⁄₂”
(775 mm)		(641 mm)	(876 mm)	(546 mm)		(286 mm)	(368 mm)

A B C

*

D E F

*

ST632

*This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page: 35¹⁄₄” in the United States and 37¹⁄₄” (946 mm) in Canada.

Encore: WITH Chimney Connector Heat Shields

	Unprotected Surfaces				Protected Surfaces
			Corner				Corner
Parallel Installations			Installations**	Parallel Installations			Installations**
Side (A)		Rear (B)	Corner (C)	Side (D)		Rear (E)	Corner (F)
30¹⁄₂”		13¹⁄₄”	25¹⁄₂”	21¹⁄₂”		7¹⁄₄”	13¹⁄₂”
(775 mm)		(337 mm)	(648 mm)	(546 mm)		(184 mm)	(343 mm)

A B C

D E F

ST632a

**To locate center of flue collar for corner installation, add 6¹⁄₂” (165 mm) to the clearance distance from stove corner to wall. Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the dia- grams above.

18 30002425