Vermont Casting 2170 manual Seneca Clearance Chart, Stove Clearance, Unprotected Surfaces, 2006063

Dutchwest Seneca

Seneca Clearance Chart

			Stove Clearance
	Unprotected Surfaces				Protected Surfaces
	Stove Installed		Stove		Stove Installed		Stove
			in				in
	Parallel to Wall				Parallel to Wall
			Corner				Corner
	Side	Rear	Corners		Side	Rear	Corners
No stove	(A) 18Ó	(B) 28Ó	(C) 21Ó		(D) 8Ó	(E) 20Ó	(F) 13Ó
heat shields	(460mm)	(710mm)	(530mm)		(200mm)	(510mm)	(330mm)
Stove, top exit with rear	(G) 18Ó	(H) 28Ó	(I) 21Ó		(J) 8Ó	(K) 20Ó	(L) 13Ó
heat shield, no connector
	(460mm)	(710mm)	(530mm)		(200mm)	(510mm)	(330mm)
heat shields1
Stove, top exit with rear	(M) 18Ó	(N) 20Ó	(O) 13Ó		(P) 8Ó	(Q) 20Ó**	(R) 13Ó
heat shield, and heat
	(460mm)	(510mm)	(330mm)		(200mm)	(510mm)	(330mm)
shields on connector1,2
Stove, rear exit with rear	(S) 18Ó	(T) 16Ó	N/A		(U) 8Ó	(V) 10Ó	N/A
heat shield only	(460mm)	(410mm)			(200mm)	(255mm)
		Chimney Connector Clearance
	Unprotected Vertical Surfaces				Protected Vertical Surfaces
No chimney connector		24Ó (610mm)				16Ó (410mm)
heat shields
Chimney connector		16Ó (410mm)				16Ó (410mm)
heat shields installed2
		Clearance to Combustibles in Front of Stove
		All Installations		48Ó (1220 mm)

1Shielding for a top exit stove must include a shield insert to protect the area behind the flue collar.

2Chimney connector heat shields must extend exactly 28Ó (710mm) above the flue collar of the stove.

**The rear clearance may be reduced to a minimum of 15Ó (381mm) and chimney connector clearance reduced to a minimum of 12Ó (305mm) if:

a.The wall shield is at least 77Ó high and 48Ó wide, and the shield is constructed as shown on Page 10.

b.The chimney connector heat shield extends exactly 23Ó (584mm) above the flue collar of the stove.

c.A 24Ó (610mm) in diameter ceiling heat shield is installed.

12 2006063