| Yes | No |
|
|
|
Is the gas type you are using the same as the gas type listed on the rating plate for this appliance?
Does the firebox meet the minimum size dimensions below?
Is the gas supply inlet pressure correct? Refer to Table below.
Is your fireplace plumbed with gas on the right side (facing) of the fireplace? If not, refer to page 5.
Is the gas supply line sized properly (Minimum 1/2” Iron pipe)?
Do you have a solid fuel (wood burning) fireplace with a vented flue?
Do you have a manual gas supply valve installed at your fireplace? If not, a licensed plumber, gas company technician or other qualified installer must install one:
Have you checked local building codes? (Check with your local building department)
Does your fireplace have a wire mesh screen in place?
CAUTION: If you answered “NO” to any item, or have any questions regarding your installation, please con- tact your dealer/distributor for assistance.
Minimum Clearances & Specifications
Natural Gas Units
Gas Log |
| Minimum Firebox Dimensions | Minimum | Gas Supply | ||||||
Set | Input | Width |
|
| Flue | Pressure | ||||
Size | Btu/hr | Back | Front | Depth | Height | Size | Minimum | Maximum |
| |
24” | 90,000 | 27” | 36” | 18” | 18” | 51 sq.in. | 3.5” w.c. | 7.0” w.c. | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Propane Gas Units |
|
|
|
| ||
Gas Log |
| Minimum Firebox Dimensions | Minimum | Gas Supply | ||||||
Set | Input | Width |
|
| Flue | Pressure | ||||
Size | Btu/hr | Back | Front | Depth | Height | Size | Minimum | Maximum |
| |
24” | 50,000 | 27” | 36” | 18” | 18” | 51 sq.in. | 11.0” w.c. | 14.0” w.c. | ||
|
|
|
|
|
|
|
|
|
|
|
Tools Required
8” adjustable crescent wrench; Pipe thread sealant compound or teflon tape; 12” pipe wrench or channel lock pliers.
Connection to Gas Supply
NOTE: For Natural and Propane gas, you must have a manual shutoff at the fireplace.
1.Place the burner pan in the fireplace. Pull the grate so the back side of the hearth brick pulls up (1, Fig. 1) enough for you to tilt the grate up (2, Fig. 1) to slide the pan underneath. (3, Fig. 1) The burn- er should be located several inches from the backwall, centered left to right.
NOTE: This is for burner connection purposes only. Exact burner placement will be covered on Page 7, after all connections have been made.
3.Attach the Gas Supply Fitting onto your fireplace’s gas supply pipe, as shown in Figure 2.
1 |
2 |
3 |
LG341 |
Fig. 1 Pull back of grate and hearth brick up, tilt front of grate up and slide burner pan under.
4 | 20007967 |
