Vermont Casting RFS22, RFS42 Glass Cleaning, Installation of Logs Burner Lava Rock, Maintenance

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circumstances present.

Clean glass after first two weeks of operation.

INSTALLATION OF LOGS &

BURNER LAVA ROCK

RFS22 & RFS32

1 . Remove front glass. (See "Glass Removal" section)

RFS42

1 .Remove Bay Window assembly and Glass Frame (see "Glass Frame Removal" section).

2.Remove logs from packaging.

3.Place rear log (SR4) on rear bracket . Ensure log is seated properly, leveled and centered to the unit), so it will not move from side to side and it is firmly positioned on the bracket.

4.Slip front ember log (SR1) down in the front deflector.

5.Place front left log (SR2) on on top of burner, left side. Use log's bottom holes to locate it into the left bracket log locator studs.

6.Place front right log (SR3) on on top of burner,right side. Use log's bottom holes to locate it into the right bracket log locator studs.

7.Place burner lava rock on top of burner. (See Fig. 17 for proper location).

8.Place top right log (SR6) onto locator notches. Ensure log is secure.

9.Place top left log (SR5) onto locator notches. Ensure log is secure.

SR5SR6

SR4

2.	Remove logs from packaging.
3.	Place rear log (KR4) on rear bracket (ensure log is
	seated properly, leveled and centered to the unit), so it
	will not move from side to side and it is firmly positioned
	on the bracket.
4.	Slip front ember log (KR1) down in the front deflector.
5.	Place front left log (KR2) on top burner, left side. Use
	log's bottom holes to locate it into the left bracket log

SR2

SR3

SR1

Fig. 17

	locator studs.
6.	Place front right log (KR3) on top of burner, right side.
	Use log's bottom holes to locate it into the right bracket
	log locator studs.
7.	Place small lava rocks and ember material on top of
	burner. (See Fig. 16 for proper location).
8.	Place top left log (KR5) onto locator notches. Ensure
	log is secure.
9.	Place top right log (KR6) onto locator notches. Ensure
	log is secure.

Top logs must be placed properly into notches

KR5KR6

KR4

KR2

KR3

KR1

Fig. 16

Burner Lava Rock Placement

Burner Lava Rock Placement

MAINTENANCE

1.It is important to keep the burner and the burner compartment clean. This must be done periodically, at least once per season. (See Cleaning Procedure).

2.Clean the brass trim using a soft clean cloth, slightly dampened with lemon oil and buff with a soft clean cloth. Do NOT use brass polish or household cleaners as these products will damage the brass trim. Lemon oil can be obtained at supermarkets or hardware stores.

3.The optional FK24 Fan requires periodic cleaning. Check the fan and the area around the fan assembly and wipe or vacuum at least once per month during the operating season.

4.Contact your local representative to arrange an annual service program.

- 10 -